Product ID:PRO-SEAL 714, PART B. 870736-01W.
MSDS Date:12/01/1989
FSC:8010
NIIN:01-324-1379
MSDS Number: BQWJH

PRODUCTS RESEARCH & CHEMICAL CORPORATION

5430 SAN FERNANDO ROAD
GLENDALE, CA 91209
US

Emergency Phone: 818-240-2060

Info Phone: 818-240-2060

Preparer: JCS

Cage: DO563

PRODUCTS RESEARCH & CHEMICAL

1800 GLENDALE, CA 91209 US

Telephone: 818-240-2060

Cage: DO563

METHYL ETHYL KETONE (2-BUTANONE) (MEK) (SARA III)

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 15 - 20%

OSHA PEL 200 PPM/300 STEL

ACGIH TLV: 200 PPM/300STEL 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

METHYL ISOBUTYL KETONE (SARA III)

CAS: 108-10-1

RTECS: SA9275000

Fraction By Weight: 15%

OSHA PEL 100 PPM/75 STEL

ACGIH TLV: 50 PPM/75 STEL; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

EPOXY RESIN

CAS: 25068-38-6

RTECS: KC2100000

Fraction By Weight: <5%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE IRRITATION/SKIN RASH TO
SKIN. EYES: SEVERE IRRITATION. LIQUID MAY DAMAGE EYE TISSUE.
PROLONGED OR REPEATED CONTACT WITH SKIN MAY CAUSE DERMATITIS.
INHALATION: VAPORS MAY BE IRRITATING TO N OSE, THROAT AND
RESPIRATORY TRACT. EXCESSIVE CAUSES HEADACHE, NAUSEA, VOMITING &
POSSIBLE DAMAGE TO NERVOUS SYSTEM.
Explanation of Carcinogenicity:THIS COMPOUND CONTAINS NO INGREDIENTS AT
CONCENTRATIONS OF 0.1% OR GREATER THAT ARE CONFIRMED OR SUSPECTED
CARCINOGENS.
Effects of Overexposure:MAY CAUSE EYE, SKIN & RESPIRATORY TRACT
IRRITATION. MAY CAUSE DIZZINESS, WEAKNESS, FATIGUE, NAUSEA,
HEADACHE, LOSS OF COORDINATION, VOMITING AND DIARRHEA. ASPIRATION
PNEUMONITIS MAY CAUSE COUGHING, LA BORED BREATHING.
Medical Cond Aggravated by Exposure:PERSONS WITH A HISTORY OF AILMENTS
OR WITH A PRE-EXISTING DISEASE INVOLVING THE EYES, SKIN, LUNGS,
KIDNEYS OR LIVER MAY BE AT INCREASED RISK FROM EXPOSURE.

First Aid:EYES: FLUSH W/LUKE WARM WATER FOR 15 MINUTES WHILE HOLDING
EYELIDS OPEN. GET MEDICAL ATTENTION IMMEDIATELY. SKIN: WASH WITH
SOAP AND WATER. REMOVE CONTAMINATED CLOTHING. GET MEDICAL ADVICE.
INHALATION : REMOVE TO FRESH AIR. GIVE MOUTH-TO-MOUTH RESUSCITATION
IF NOT BREATHING. GET MEDICAL ATTENTION. INGESTION: DO NOT INDUCE
VOMITING. RINSE MOUTH & DRINK LARGE AMOUNTS OF WATER. GET MEDICAL
ATTENTION.

Flash Point Method:PMCC
Flash Point:30 F FLAMMABLE.
Extinguishing Media:WATER, FOAM, DRY CHEMICAL, WATER.
Fire Fighting Procedures:USE AIR SUPPLIED RESPIRATOR. USE WATER TO
COOL HEAT EXPOSED CONTAINERS.
Unusual Fire/Explosion Hazard:COMBUSTION OR HEAT OF FIRE MAY PRODUCE
HAZARDOUS DECOMPOSITION PRODUCTS AND VAPORS. HIGH TEMPERATURES MAY
CAUSE PRESSURE BUILDUP IN CLOSED CONTAINERS.

Spill Release Procedures:REMOVE ALL IGNITION SOURCES. SCOOP INTO
CONTAINERS. CLEAN-UPRESIDUE W/1,1,1 -TRICHLOROETHANE.
Neutralizing Agent:DILUTE WITH WATER

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE. KEEP
CONTAINERS CLOSED WHEN MATERIAL IS NOT IN USE. KEEP AWAY FROM
IGNITION SOURCES. AVOID PROLONGED OR REPEATED CONTACT.
Other Precautions:NONE

Respiratory Protection:WEAR A NIOSH/MSHA APPROVED CHEMICAL CARTRIDGE
RESPIRATOR WITH FULL FACEPIECE AND ORGANIC VAPOR CARTRIDGES IN
COMBINATION WITH A HIGH-EFFICIENCY PARTICULATE FILTER.
Ventilation:LOCAL AND MECHANICAL(GENERAL) EXHAUST TO PROVIDE ADEQUATE
VENTILATION.
Protective Gloves:SOLVENT RESISTANT GLOVES.
Eye Protection:CHEMICAL GOGGLES OR FULL-FACE SHIELD.
Other Protective Equipment:WEAR INDUSTRIAL WORK CLOTHING. USE RUBBER
APRON OR BOOTS IF NEEDED. HAVE EMERGENCY EYE WASH AND SAFETY SHOWER
AVAILABLE.
Work Hygienic Practices:WASH THOROUGHLY AFTER HANDLING AND BEFORE
EATING, DRINKING OR SMOKING. LAUNDER CONTAMINATED CLOTHING BEFORE
REUSE.
Supplemental Safety and Health
AVOID PROLONGED OR REPEATED EXPOSURE. DO NOT GET ON SKIN OR IN EYES. DO
NOT BREATHE VAPORS OR MIST. DO NOT INGEST. READ PRECAUTIONS ON
LABEL BEFORE USE.

HCC:N1
Spec Gravity:1.18
Evaporation Rate & Reference:UNKNOWNN-BUTYL ACETATE=1)
Solubility in Water:MODERATE.
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:HIGH HEAT, OPEN FLAMES AND OTHER SOURCES
OF IGNITION
Hazardous Decomposition Products:OXIDES OF CARBON.

Waste Disposal Methods:DISPOSAL OF WASTE AND HAZARDOUS MATERIAL SHALL
COMPLY WITH LOCAL, STATE AND FEDERAL ENVIRONMENTAL PROTECTION
AGENCY REGULATIONS. SEND WASTE MATERIAL TO AN APPROVED RECYCLING
FACILITY IF FEASIBLE. CITY , STATE AND FEDERAL REGULATIONS MUST
BEFOLLOWED.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.